CMM Programmer

Job Description

To provide CMM inspection and metrology support to production and support areas to ensure conformance to customer, regulatory and / or internal requirements. Assigned duties may change due to business changes and production needs

Qualifications

• CMM Programmer will be assigned to the following discipline. Ability to use the various other gauges and hand held measuring instruments is also required.

• Able to program CMM’s using the Calypso / PC-DMIS Software for complex parts with advanced GD&T call outs.
• Support Calibration by measuring gauges.
• Support APQP and PPAP activities (supplier and internal).
• Support assembly areas with measurement data for problem solving.
• Able to program and using a variety of measuring equipment for complex parts.
• Able to generate layout reports that clearly show status of parts measured.
• Preparing of the test sequence, including preparation of equipment.
• Troubleshooting of problems.
• Performing servicing and maintenance of measuring equipment when applicable.
• Verify conformity of submitted supplier or internal PPAP’s per SQE’s or QE’s recommendations.
• Complete and submit proper paperwork in a timely manner for each layout clearly identifying non-conformances.
• Travel when necessary to further education on CMM & supporting software.

• Perform product audits in a timely manner per the audit schedule.
• Ensure the quality labs are kept organized, clean, and all production material identified.
• Support manufacturing floor (operators) in quality issues.
• Report any concerns, especially in the case where non-conforming material may be shipped to the customer, to supervisor or Quality Manager.
• Write technical reports and documentation.
• Other tasks may be assigned as needed to support production / company needs.

Additional Information

Three to five years related experience and or training. Experience should be gained in areas of technical operations and should include a minimum of two years in Quality for experienced candidates. One to five years experience in manufacturing/assembly operations for entry level candidates.

By choice, we are committed to a diverse workforce - EOE/Protected Veteran/Disabled.